Shut in Q1 2020

===================== 

EQUIPMENT OVERVIEW

=====================

Was in operation as a site inlet separator for a compressor station in Central AB up until 2014 when it was shut in.  It’s a very clean unit that is on high grade roads and can be easily redeployed.

• Vessel is 200cu ft.

• There are no TOL’s on vessel. Flange connections only.

• 16″ O.D. x 22″ long water boot.

• Vessel in/out is 10″ 150#. After the vessel discharge is a 10″ check valve, and then there is a swage down to 8″600#. This is for the Canalta dual chamber 8″600# meter run.

• Gas flow is calculated with a FloBoss totalizer/transmitter. After the meter run, the pipe size goes back up to 10″150#.

• 10″ 150# inlet ESD valve with a manual bypass line inside the building.

• Norriseal level controllers for high-level alarm and for high-level s/d.

• Kimray dump valve with manual bypass.

• Centrifugal water transfer pump.

==========

DRAWINGS

==========

Drawings are available by downloading a PDF file in the documents tab.

==================

FEATURE SHEETS

==================

A  feature sheet is available on the documents tab for yourself or to share with your customer network.

=========================

ADDITIONAL INFORMATION

=========================

Condition:

Used

Manufactured:

BS&B 2006

Location:

Central Alberta

Availability:

Immediate / 1 Week for disconnect

Registration:

AB, U&W stamped

Status:

Connected

Service:

280psig MAWP, Sweet; 3 phase dressed 2 

Connections:

10" Inlet / Outlet; 4" Liquid dump line, 4" drain, 16" x  22" water boot, fully flanged, no TOL's

Building:

30' x 12' Skid (25'L Building). 13'9" SH . Two (2) single man doors, windows, Cata-dyne heater

Electrical:

Three inside AC lights, one outside AC light, one exhaust fan, gas detection head/display, outside ESD button wired to JB's