2 units per 120 KW

Engin manufactoring 2017

Genset was rerated when purchased from Cat. Can re rated/set up differently for a new customer.

Package 1000034114

Generator  1000013328

Engine  1000013328

PSV 1000016431

BuildingPackage 1000034160 

This 600kw genset package houses a Thomson Power Systems Series 2200 Paralleling transfer control switchboard including a master controller and tie breaker. This package also has a unit mounted 600kw load bank.

------------------------

Waukesha VGF L36GL(HCR)  Engine 480V: Serial Number:  5283705339

Stamford Alternator:  H3634G1 Serial Number:  X17C101703

Control Panel: Thomson Power Systems:  ComAP InteliGen NT

Switchgear: Thomson Power Systems GCS W-097256:  ComAP InteliGen NT

Battery Charger: LaMarche Model:  ESCR-10-24V-AV1: Serial Number:  367907-7(3718)

Waukesha VGF L36GL(LCR)  Engine 480V: Serial Number:  5283705338

Stamford Alternator:  H3634G1 Serial Number:  X18D001703

Control Panel: Thomson Power Systems: 

Battery Charger: LaMarche Model:  ESCR-10-24V-AV1: Serial Number:  Serial# 367906-8 (3718)

DOES NOT INCLUDE LOAD BANK

Package Number 66212643

Engine # 66212645

Generator # 66212646

Includes Instrument Air Package, 2011, Electric, 7.5 hp, 460V, Vane COMPAIR, model HV05, 130 psig.

This genset package also contains the MCC & boiler for this site. The MCC end contains an obsolete PLC, furnace, 24VDC rectifier, and main breaker system for the site. The genset end of the building contains a main & standby generator, as well as the switchgear & control panel for the gensets. The boiler & pumps for heating the other buildings is also in this end of the building. The boiler is a Raytherm 2.25MMBTU/hr unit. S/D spring 2019

MORE PICTURES TO COME

Description:

1. GE 7EA GTG Packaged Power Plant.

The package comprises the following major components along with all GE scope of supply and auxiliaries:

• Frame 7EA Gas Turbine model PG7001EA (7E.03)

• Dry Low NOx (for DLN 1.0 Combustion System)

• Natural gas single fuel supply

• Output/Heat Rate 87MW and 10,480 btu/kwh at 1916 ft

• Includes GE PIP package (minus Stg 3 Aero), 2055F firing temp.

• Inlet/Exhaust: Pressure drop: 3.5/5.5 inches of H2O

• Design site elevation: approx. 1916ft above sea level.

• Hours: factory test fire only, ie New.

• Control System; MKV1e Speedtronic TMR.

• Generator; GE/Andritz

• Frame: BDAX (Brushless)

• Excitation: GE EX2100

• Terminal Voltage: 13.8Kv (2 pole, 3-phase, Wye conn.)

• Frequency/Power Factor: 60 Hz/0.85 pf

• Rated Output: 86.5 mw/101.8 MVA

• 52G synchronizing breaker compartment included @ 13.8KV incl. all protection relays etc.

• Cooling: Air-cooled.

• Design for Canadian Market. Stored in accordance with GE's storage/preservation requirements.

Additional Options:Combustor Components to be selected and agreed upon between buyer and seller. Contact seller for more information

Please refer to supporting documents for more information.

55 KW Cummins NG Generator

145 KW Generator

MCC/60KW Generator and Instrument Air Skid

60W Generator Package

175KW Primary, 150KW Backup Generator Package

582W Generator Package

Ready for prime or stand-by power, this Waukesha L7042GL powered package makes 1 MW / 1000 kW of power with only 34,000 hours on overhauled components. The engine has been preserved, features a 62 kW black start generator and an air compressor system for a complete facility. It’s currently disconnected in a yard beside highway #22, which is high load corridor for easier logistics. Additionally, this package is a perfect candidate for a conversion to multi-stage pump.

View Virtual Tour

Waukesha L7024GL

• VHP, 12 cylinder
• Rated 1472 HP – 1097 kW @ 1200 RPM
• Rated Continuous Service
• Fuel – Natural Gas

Propak Fin Tube Aerial Cooler Assembly

• Jacket water section
• After-cooler section
• Belt Driven Fan from Engine

KATO 1000 kW Generator Assembly

• 6P6-1900 1000Kw/1250 KVA
• 277/480/3/60 VAC
• 1504 Amps
• Rated Continuous Service

Thompson MEC-20 Micro Controller Panel

• Synchronous Generator/Engine Controller
• Woodward Governor Control
• Main Breaker
• Engine Monitoring Annunciator

Kohler 60 kW Black Start Unit

• Engine – John Deere 4045TF150C
• Fuel – Diesel
• Generator – Kohler 60REQZI
• 62 kW
• 277/480/3/60 Vac
• 71 Amps

Eagle Instrument Air Compressor

• Qty. 2 screw compressors
• Qty. 2 TECO 20 HP, 480/3/60 VAC motors
• 100 Gallon Storage tank
• Automated air dryer assembly

Building & Skid

• Length 40’
• Width 20’
• Height 22’
• Weight 100,000 lbs.
• Qty. 4 Lifting lugs on each side of the skid/building assembly.

Additional Cooler Dimensions

• Width 20’
• Length 10’
• Height 12’

Highlights for 1 MW Generator Redeployment

Whether you’re going to redeploy this generator in its original configuration, with minor adjustments or alternatively convert it to a multi-stage pump package with our help – we have the knowledge and expertise to get this package producing for your needs.

Engine – Engine has 34,000 hours on it since major overhaul. It requires a head swing and turbos. The full scope of work can be completed in one week prior to leaving yard with detailed pricing available on request. Engine has been preserved.

Electrical – The panel & complete electrical system has received a detailed inspection and scope of work required by DJA Electrical Services. Unit electrical requires $2700 worth of parts to be 100% operational and current.